VMQ o ring or MVQ o ring,chemical name is silicone rubber o ring, as one of the most common rubber material,it is been used in static working conditions or as a piece of energizer part of composite seals in dynamic sealing conditions.
Ductile Iron Castings.Ductile iron has the castability, machinability and corrosion resistance of gray cast iron, as well as the high strength, high toughness and hardening ability of steel.Process: 1.Green sand casting process 2.Pre-coated sand casting p
AZ31 Magnesium Plates are used on a large scale for the manufacture of automotive front and rear covers, automotive door panels, motor car casings, motor car bases and beds, and aerospace vehicles such as airplanes and rockets.
61800, 61900 single row deep groove ball bearing with bore diameter 15 ~ 80mm. 1. Thin section type radial ball bearing.2. Open/ZZ(shielded)/2RS(sealed) type available.3. Mainly support radial loads, can also take moderate axial loads in both direction.4.
Rubber o-rings offer the designer an efficient and economical sealing element for a wide range of static or dynamic applications. Inexpensive production methods and its ease of use have made the o-ring the most widely used seal.
Chrome steel balls (GCr15/52100/100Cr6) are primarily used in precision ball bearings and in a large variety of industrial applications, like vehicles components, machine tools, valves, bikes and pumps.
Inch cylindrical bushing consists of a low carbon steel backing, an intermediate layer of sintered bronze, PTFE based sliding lining. About marginal sliding bearing ,There are the wrapped cylindrical bushings . From a technical point of view, the product
Product introduction: We manufacture high quality API certified power station gate valve which is applied to oil and gas, power station, petrol chemical and processing industry. We devoted ourselves to industrial valves in line with the most recognized in
Product Details ABS open mold injection molding mold temperature: The cooling of the product is very good and has a great influence on the quality. Therefore, the mold temperature must be able to accurately control the process. If possible, the mold tempe